Operating Other Manufacturers’ Equipment

7To change the transmittable signals for operating other manufacturers’ VCR

2. Press VCR.	TV	TAPE	CDR	FM/AM
	TV DIRECT	STB	VCR	DVD

3. Enter the manufacturer’s code	EFFECT	CENTER
using the number buttons (1–9, 0).	1	2	3
using the number buttons (1–9, 0).	TEST	REAR·L
See the right to find the code.	TEST	REAR·L
See the right to find the code.	4	5	6
	SURR ON/OFF	REAR·R
	7	8	9
	SURR MODE – SUBWOOFER +
	10/0	+10
		100+

4. Release STANDBY/ON VCR.

You can turn on and off the VCR:

STANDBY/ON VCR : Turns on or off the VCR.

After pressing VCR, you can perform the following operations on a VCR:

1 – 9, 0 : Selects the TV channels on a VCR. For channel number 5, press 5.

For channel number 10, press 1, then 0. For channel number 23, press 2, then 3.

TV RETURN will function as the ENTER button if your equipment requires pressing ENTER after selecting a channel number.

3: Starts playing.

REW : Rewinds a tape.

FF: Fast-winds a tape.

7 : Stops operations.

8 : Pauses playing. To release it, press 3.

Note:

• Refer also to the manual supplied with your VCR.

When your VCR turns on or off, you have entered the correct code.

If there are more than one code listed for your brand of

VCR, try each one until the correct one is entered.

*“00” is the initial JVC code.

Note:

•Manufacturers’ codes are subject to change without notice. If they are changed, this remote control cannot operate the equipment.