JVC RX-DV3RSL manual Getting Started, Connecting the FM and AM Antennas, 3Release the clamp

Getting Started

Connecting the FM and AM Antennas

AM loop antenna (supplied)

If AM reception is poor, connect an outdoor single vinyl-covered wire (not supplied).

If FM reception is poor, connect outdoor FM antenna (not supplied).

Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna.

B

75 FMCOAXIAL

75

FMCOAXIAL

AM LOOP

FM antenna (supplied)

		FM 75
AM
EXT		COAXIAL
	ANTENNA

1

2 3

1 RIGHT LEFT

FRONT SPEAKERS

CAUTION: SPEAKER IMPEDANCE

16

2

AV COMPU LINK-

RIGHT	LEFT			DIGITAL IN	DIGITAL OUT
CENTER	REAR	SUB-
SPEAKER	SPEAKERS		DIGITAL 1	DIGITAL 2
		WOOFER
		OUT	(DBS)	(TV)
		AV	IN/OUT		PCM/STREAM
		VCR		STB
			AV IN
TAPE / CDR	AUDIO
LEFT		TV		AM LOOP

RIGHT	RGB	YC
				FM 75
OUT	IN		AM EXT	COAXIAL
(REC)	(PLAY)			ANTENNA

Rear panel of the unit

AM antenna connection

Connect the AM loop antenna supplied to the AM LOOP terminals.

1Remove the insulation if the AM loop antenna wire is covered with vinyl.

2Press and hold the clamp of the terminal (1), then insert the wire (2).

3Release the clamp.

Turn the loop until you have the best reception.

•If the reception is poor, connect an outdoor single vinyl- covered wire (not supplied) to the AM EXT terminal. Keep the AM loop antenna connected.

FM antenna connection

Connect the FM antenna supplied to the FM 75 Ω COAXIAL terminal as temporary measure.

Extend the supplied FM antenna horizontally.

•If the reception is poor, connect an outdoor FM antenna (not supplied). Before attaching a 75 Ω coaxial cable (with a

standard type connector), disconnect the supplied FM antenna.

Note:

•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.

5