JVC RX-DV5SL manual Turning Off the Power With the Sleep Timer, Changing the Source Name

Turning Off the Sounds Temporarily	Changing the Display Brightness
MUTING	DIMMER
From the remote control ONLY	From the remote control ONLY

English

Press MUTING to mute the sound.

“MUTING” appears on the display and the volume turns off (the VOLUME indication goes off).

•When DVD is selected as the source with your TV turned on, “VOLUME –” appears on the TV.

DIGITAL AUTO

L R SPK.

To restore the sound

Press MUTING again.

•Pressing VOLUME + or – on the remote control (or turn MASTER VOLUME on the front panel) also restores the sound.

Turning Off the Power

with the Sleep Timer

SLEEP

From the remote control ONLY

Press SLEEP repeatedly.

The SLEEP indicator lights up on the display.

•Each time you press the button, the shut-off time changes as follows:

		SLEEP indicator
DIGITAL AUTO
L R	SPK.	SLEEP
		VOLUME

10 20 30 60

0 (off) 150 120 90

When the shut-off time comes

The unit is turned off automatically.

To check or change the remaining time until the shut-off time

Press SLEEP once.

The remaining time (in minutes) until the shut-off time appears.

•To change the shut-off time, press SLEEP repeatedly.

To cancel the Sleep Timer

Press SLEEP repeatedly until “SLEEP 0” appears on the display. (The SLEEP indicator goes off.)

•Turning off the unit also cancels the Sleep Timer.

Note:

•If Auto Standby (see page 54) and Sleep Timer are used at a time, one with the early shut-off time will turn off the unit.

Press DIMMER to dim the display.

•Each time you press the button, the display and illumination lamp dim and brighten alternately.

Changing the Source Name

When you connect an CD recorder to the TAPE/CDR jacks on the rear panel, change the source name which will be shown on the display.

TAPE/CDR

SOURCE NAME

On the front panel ONLY

Ex. : When changing the source name from “TAPE” to “CDR”

1Press TAPE/CDR (SOURCE NAME) to select as the source.

2Press and hold SOURCE NAME (TAPE/CDR) until “ASSGN. CDR” appears on the display.

ANALOG

L R VOLUME

ASSGN. TAPE ASSGN. CDR

To change the source name to “TAPE”

Press and hold SOURCE NAME (TAPE/CDR) until “ASSGN. TAPE” appears on the display in step 2.

Note:

•Without changing the source name, you can still use the connected components. However, there may be some inconveniences:

–The unexpected source name will appear on the display when you press TAPE/CDR (SOURCE NAME) on the front panel.

–The CDR or TAPE button on the remote control cannot work for selecting the source.

–You cannot use the digital input (see page 10) for the CD recorder.

12