JVC SR-DVM600U Audio Dubbing DV Deck Only, Input Select on the unit to select AF-1B, Audio Output

54 EN EDITING

	Audio Dubbing (DV Deck Only)				● Slide the TV/DVD switch to DVD.
				1		Connect an audio device to the unit’s [AUDIO] input connectors
This function allows you to record new audio, without erasing the
original audio, on a DV tape that was recorded with ADV AUDIO						on the front panel.
					● When using a monaural audio device, connect its AUDIO OUT
RECB set to A12BITB (A pg. 60).
						connector to the [AUDIO-L] input connector on your unit.
				2
ATTENTION:						Load a Mini DV cassette with the erase protection switch set to
You cannot perform Audio Dubbing on a tape that was recorded				3		ARECB.
						Press DV/HDD/DVD on the unit repeatedly or DV on the remote
with ADV AUDIO RECB set to A16BITB (A pg. 60), on a tape that
was recorded at the ALPB speed, or on a blank tape.				4		so that the DV lamp lights up on the unit.
						Press INPUT SELECT +/– on the remote control or
		Your unit	Recorder			INPUT SELECT on the unit to select AF-1B.
					5 Start playback slightly before the actual point from where you

wish to start dubbing.

INPUT SELECT AUDIO DUB.

To [AUDIO] input

6Press W to pause playback.

7Press AUDIO DUB. to engage the audio dubbing mode.

●Your unit enters the Audio Dubbing Pause mode.

●To perform Audio Dubbing with audio mixing, press AUDIO to select AL W X RB at this point. When using the DV deck as the recording deck, also make sure that AAUDIO MODEB is set to ASOUND1B (A pg. 60).

Audio cable	* Audio Dubbing with audio mixing is not possible if you are using a
(not supplied)	monaural audio component, or if you don’t have an audio mixer.

AUDIO OUT

CD player, etc.

CD player, etc.

Mixer output

Original sound

Your unit [AUDIO OUTPUT]

Audio mixer

Recorder

8Engage the audio device’s playback, then press I to start the tape in the unit. Audio dubbing starts at this point.

●To stop dubbing temporarily, press W. Press I to resume dubbing.

9Press o on the unit, then stop playback on the audio device to end the audio dubbing.

NOTES:

●When monitoring the audio dubbed sound on the DV deck, set AAUDIO MODEB to ASOUND2B (A pg. 60).

●When playing back an audio dubbed Mini DV tape on the DV deck, set AAUDIO MODEB to ASOUND2B (A pg. 60).

●Audio dubbing is not possible using the [DV IN/OUT] connector.

●Audio dubbing is not possible on a blank portion of the tape.

To	INPUT SELECT	AUDIO DUB.
[AUDIO]
input