Masterpage:Left-FullCol
14 EN
Filename [SR-V10E1a-EN.fm]
Page 14 August 19, 2002 10:13 am
INITIAL SETTINGS (cont.)
Results of Auto Set Up appear on the front display panelIf both Auto Channel Set and Auto Clock Set have been performed successfully, the
correct current time is displayed.
Turn on the TV and select its video channel or AV mode, then make sure that all necessary stations
have been stored in the recorder’s memory by using the PR button(s).
●If station names (ID – 墌pg. 55) have also been stored in the recorder’s memory, the station
name will be displayed at the upper left corner of the TV screen for about 5 seconds when the
recorder is tuned to a different station.
●If you want to set the tuner manually such as to add or skip channels, to change channel
positions, or to set or change station names, see pages 52 – 55.
If Auto Channel Set has succeeded but Auto Clock Set has not, “1” (channel position) is
displayed.
ATurn on the TV and select its video channel or AV mode, then make sure that all necessary
stations have been stored in the recorder’s memory by using the PR button(s).
●If station names (ID – 墌pg. 55) have also been stored in the recorder’s memory, the station
name will be displayed at the upper left corner of the TV screen for about 5 seconds when the
recorder is tuned to a different station.
●If you want to set the tuner manually such as to add or skip channels, to change channel
positions, or to set or change station names, see pages 52 – 55.
BPerform “Clock Set” on page 56.
If both Auto Channel Set and Auto Clock Set have failed, “––:– –” is displayed.
Make sure the cables are connected properly and turn off the recorder’s power once, then turn the
recorder’s power back on again.
The Country Set display appears on the TV screen; perform “Auto Set Up” on page 12 again.
IMPORTANT
●To check if the Guide Program numbers have been set correctly, perform the SHOWVIEW Timer Programming (墌pg.28).
●In certain reception conditions, station names may not be stored correctly, and auto Guide Program Number Set may not work
properly. If the Guide Program numbers are not set properly when you timer-record a TV programme using the SHOWVIEW
system, the recorder will record a TV programme of a different station. When programming the timer using the SHOWVIEW
system, be sure to check the desired channel is selected correctly (墌pg.28, “SHOWVIEW® Timer Programming”).
●Your video recorder memorizes all detected stations even if reception of some of them is poor. You can delete those stations with
an unacceptable picture (墌pg.53, “Delete A Channel”).
INFORMATION
Just Clock
Your recorder is equipped with the Just Clock function which provides accurate time keeping through automatic adjustments at
regular intervals, by reading data from a PDC signal. If you want to take advantage of this function, simply set it to “ON”
(墌pg. 56, “Just Clock”).
Last-Function Memory
When the power plug is removed from the recorder or when the power failure occurs, your settings for the following functions are
kept in memory if the lithium battery is not exhausted. These settings will resume when the recorder is turned on again.
●Input selection (channel or auxiliary input; L-1, F-1, S-1, or S-2)
●Country setting (墌pg. 12)
●Recording tape speed (墌pg. 19)
●Mode settings (墌pg. 44 – 48)
SR-V10E1-EN.book Page 14 Monday, August 19, 2002 10:20 AM