JVC SR-V10E 46 EN, Screen, Set PROG. Navigation to OFF, While timer-recording in SP mode

46 EN		SUBSIDIARY SETTINGS (cont.)
		* The default setting is bold in the table below.
8 O.S.D. (PLAY)	When this function is set to “ON”, various operational indicators appear on the TV
ON	screen.
OFF	NOTES:
	● When you use this recorder as the source player for editing, be sure to set “O.S.D. (PLAY)” to
	“OFF” before starting.
	● During playback, the operation mode indicators may be disturbed depending on the type of
	tape being used.
8 PROG. NAVIGATION	When this function is set to “ON”, the recorder stores information on the recorded
ON	programmes. If you do not want to use the Programme Navigation function ( pg. 36),
OFF	set “PROG. NAVIGATION” to “OFF”.
	NOTES:
	● Programme Navigation is possible with the cassettes recorded with this recorder only.
	● Before recording, make sure the recorder’s clock is set correctly.
	● To record the programme information in this recorder’s memory, you must continue to record
	each programme for over the minimum recording time; 8 minutes for the SP mode, 15 minutes
	for the LP mode or 23 minutes for the EP mode.
	● Programme Navigation may not work properly depending on the tape being used.
	● The programme information is stored in this recorder’s memory. If the memory in this recorder
	should ever be damaged and the programme information lost, it is impossible to restore that
	information.
8 AUTO SP]LP TIMER	When this function is set to “ON”, the recorder automatically switches to LP mode to
ON	allow complete recording if there is not enough tape to record the entire programme
OFF	while timer-recording in SP mode.
	For Example . . .
	Recording a programme of 210 minutes in length onto a 180-minute tape
	Approximately 150 minutes	Approximately 60 minutes
	SP mode	LP mode
	Total 210	minutes
	Make sure you set this function to “ON”, before the timer-recording starts.
	NOTES:
	● If you have programmed the recorder to timer-record 2 or more programmes, the second
	programme and those thereafter may not fit on the tape if you set “AUTO SP]LP TIMER” to
	“ON”. In this case, make sure the mode is not engaged, then set the tape speed manually
	during timer programming.
	● In order to ensure that the recording fits on the tape, this feature may leave a slight
	non-recorded section at the end of the tape.
	● There may be some noise and sound disturbance at the point on the tape where the recorder
	switches from SP to LP mode.
	● The Auto SP]LP Timer feature will not work properly with any tapes longer than E-180, or with
	some tapes of shorter lengths.
	● If you perform timer recording with both VPS/PDC and the Auto SP]LP Timer activated, and
	the programme goes beyond its originally scheduled length, there may be times when the
	programme cannot be recorded in its entirety.