Filename [SR-V10E2-EN.fm]
Masterpage:Left
28 EN
Page 28 September 3, 2002 10:32 am

TIMER RECORDING

SHOWVIEW® Timer Programming
With the SHOWVIEW system, timer programming is greatly
simplified because each TV programme has a corresponding
code number which your recorder is able to recognize.
AAccess the SHOWVIEW screen.
The front display panel looks like this:
BEnter the SHOWVIEW number.
The SHOWVIEW number you enter appears on the front display
panel with only a 4-digit number:
CAccess the SHOWVIEW Program screen.
The front display panel shows the programme number. Pressing
" changes the display to the programme start time, the stop
time, the date, the tape speed then the channel position.
●If the number you entered is invalid, “ERROR” appears on the
TV screen and “Err” appears on the front display panel. Press
& and input a valid SHOWVIEW number.
●If the “GUIDE PROG SET” screen appears, see “ATTENTION”
on page 29.
Before performing the SHOWVIEW Timer
Programming:
●Make sure that the recorder’s built-in clock is set properly.
●Insert a cassette with the safety tab in place. If the tab has
been removed, set “REC SAFETY” to “OFF” (墌pg.48).
The recorder will come on automatically.
●Turn on the TV and select the video channel (or AV mode).
ATTE NTI ON
It is impossible to perform timer programming during
recording.
Press PROG.
Press the number keys to
enter the SHOWVIEW number
of a programme you wish to
record.
●If you make a mistake, press &
and input the correct number.
Press OK and the SHOWVIEW
Program screen appears (if
you’re just starting out, “P1”
appears).
IMPORTANT
Make sure the channel position number you wish to record is
displayed; if not, see “SHOWVIEW® System Setup” on page49
and set the Guide Program number correctly.
SR-V10E2-EN.fm Page 28 Tuesday, September 3, 2002 10:32 AM