JVC SR-V10E Correction to the luminance signal to enhance detail, Recorder is turned off, Setting

	EN 47
	* The default setting is bold in the table below.
8 DIGITAL 3R	When this function is set to “ON”, the Digital 3R picture system applies edge
ON	correction to the luminance signal to enhance detail.
OFF	NOTES:
	● Normally it is recommended to keep “DIGITAL 3R” set to “ON”.
	● Depending on the type of tape being used, picture quality may be better with “DIGITAL 3R” set
	to “OFF”.
	● If you use the recorder as the source player for editing, be sure to set “DIGITAL 3R” to “OFF”
	before starting.
8 POWER SAVE	When this function is set to “ON”, you can reduce the power consumption while the
ON	recorder is turned off.
OFF	NOTES:
	● During Power Save mode ...
	... the front display panel will be turned off.
	... the Just Clock function ( pg. 56) does not work.
	... the picture may be distorted momentarily when you turn on/off the recorder.
	● Power Save does not work when ...
	... the recorder is in the Timer mode.
	... the recorder’s power is turned off after timer-recording.
	... the Automatic Satellite Programme Recording mode is engaged ( pg. 35).
8 VIDEO STABILIZER	When this function is set to “ON”, you can automatically correct vertical vibration in
ON	the picture when playing back unstable recordings made on another recorder.
OFF	NOTES:
	● When you finish viewing a tape, be sure to set this function to “OFF”.
	● Regardless of the setting, this function has no effect during recording and during special effects
	playback.
	● The on-screen display may jitter vertically when this function is set to “ON”.
	● To watch recordings with close-caption, set this function to “OFF”.
	● Video Stabilizer and Digital TBC/NR cannot be used at the same time. If you activate Digital
	TBC/NR when “VIDEO STABILIZER” is set to “ON”, Video Stabilizer will be automatically
	turned “OFF”.
8 S-VHS	Your recorder can record in S-VHS (Super VHS), S-VHS ET or VHS.
ON	●To record in S-VHS:
OFF
	Set “S-VHS” to “ON”. Then, insert a cassette marked “S-VHS”. The S-VHS indicator
	lights up on the front display panel.
	The S-VHS recording mode is selected.
	●To record in S-VHS ET on a VHS cassette:
	See “Super VHS ET (S-VHS ET)” on page 22.
	●To record in VHS:
	Insert a cassette marked “VHS”.
	Press S-VHS ET on the recorder. You can check the current setting (“S-VHS ET : ON” or
	“S-VHS ET : OFF”). If “S-VHS ET : ON” appears on the TV screen, press S-VHS ET
	again in about 5 seconds to set it to “OFF”.
	The VHS recording mode is automatically selected regardless of the “S-VHS” mode
	setting.
	●To record in VHS on an S-VHS cassette:
	Insert a cassette marked “S-VHS”. The S-VHS indicator lights up on the front display
	panel. Then, set “S-VHS” to “OFF”. The S-VHS indicator goes off.
	The VHS recording mode is selected.
	NOTE:
	When playing back a tape that has been recorded in S-VHS or S-VHS ET, the S-VHS indicator
	lights up on the front display panel regardless of the “S-VHS” mode setting.