JVC VR601 View the VR-601 video from a remote PC, URL of a Proxy, Port, Modify, Delete, Connect

Physical specification for Ethernet

Wire Type	Cat. 5
Connector Type	RJ-45
Max. Cable Length	30 m
Hub Wiring Configuration	Straight Through
PC Wiring Configuration	Cross Over

NOTE: For more details on network connections, please refer to the following document.

10.1.2Install the Network Viewer in your PC

Install the Network Viewer from the supported CD-R.

1.Exit all applications currently running in the selected PC.

2.Insert the supported CD-R in the CD-ROM drive. The program will execute the installation automatically. Follow the on-screen instructions to proceed with the rest of the installation procedure as they appear.

3.After the installation is complete, pop up the START menu from your computer, and point to Programs / JVC Picture Viewer to open up the program selection page as shown below. Click the Network Viewer tag to start the Network Viewer program.

NOTE: The number of Network Viewer that can be simultaneously connected to VR-601 is one.

NOTE: If the Network Viewer needs to be upgraded, please contact your JVC dealer.

NOTE: Please make sure the TCP/IP communication software has been properly set and configured in your computer. To check your TCP/IP settings, refer to the following document.

NOTE: When the Alarm Operation is ON, The image software (Network Viewer) doesn't show the pictures and a message will be displayed.

NOTE: The maximum refresh rate on live mode (REC or STOP) is 2F/S. It depends on the network speed.

10.1.3View the VR-601 video from a remote PC

Follow the instructions below to use the Network Viewer to browse a VR-601 video from a remote location. Upon entering the Network Viewer; the connection box will appear as follows.

1.Choose a channel number from the Channel drop-down list.

2.Assign a name for the chosen VR-601.

3.Type in the password and IP of the device and click the Add tag to add the device to the connection list.

4.Click the Connect tag to establish the connection between the devices and the computer. Click OK to begin viewing images.

NOTE: Upon connection, the connection status box indicates the name and IP address of the selected device. If there’s a failure to connect, a “Fail” message appears on the screen right after the device IP address; otherwise an “OK” appears. To add more connections or units to the VR-601, please repeat the above instructions.

Functions	Description
z Channel	Assign a display location when you have multiple devices connected.
z Name	This box allows you to assign a name to the chosen device.
z Password	Type the preset password for making a connection.

zURL of the Remote Device Type the IP address which you preset for the device

z URL of a Proxy	Type your proxy server address when accessing the Internet via a proxy
z Port	server.
	Enter the designated port setting of your proxy server.
z Modify	Click to change the settings of a chosen device.
z Delete	Click to remove the connection of a chosen device
z Connect	Click to establish the connection between the devices and the computer.
z OK	Click to access the display page of the Network Viewer
z Cancel	Click to exit the program of the Network Viewer.

62 63