JVC VR601 instruction manual Installation, Basic Connection, Connectiong to the AC Adapter

3. INSTALLATION

Please follow the instructions and the diagram below to set up the system.

3.1 Basic Connection

CONNECTIONG TO THE AC ADAPTER

Connect the provided AC adapter to the main unit.

					Screw
			SD Card		Clamp
	FROM MUX
VIDEO	MAIN MONITOR
		AUDIO	RS-485
	IN	IN
		ETHERNET	RS-232
		10/100
		OUT
	OUT
TO	TO		ALARM	I/O	DC12V
MUX'S VCR IN	MONITOR

AC	DC IN terminal
	DC cord

Provided AC

mains cable Provided AC adapter (model:STD-1205)

1.Connect the DC cord of the AC adapter to the DC IN terminal of the main unit.

2.To prevent accidental disconnection of the DC cord, fasten the DC cord with a wire catch.

1)Remove 1 screw followed by the wire catch.

2)Insert the DC cord into the wire catch and fasten the wire catch unto the main unit.

3.Connect the provided power cord to the AC IN terminal of the AC adapter.

4.Connect the power cord to the power socket.

•Power is channeled into the unit and the OPERATE indicator lights up green. (OPERATE ON mode)

•Press OPERATE button for at least 3 seconds to power off and the OPERATE indicator lights up orange. (OPERATE OFF mode)

The orange light signals the hard-disk drive is power stand by.

Memo

•Even in the OPERATE OFF mode, a small amount of electricity will still flow into the unit.

•When the unit is in the OPERATE OFF mode, no operation can be performed except that of the OPERATE button.

•It might show an error message "DATA ERROR" and stop recording when the condition of main power is not stable. When this is assumed, please use an uninterruptible power supply (UPS). When an error message is displayed, please reboot the VR-601 by turning the operation button OFF and ON, or unplug and plug the AC power line.

*About the location of the buttons, please refer to Page 10 2.1 Front View.

Note:

•Please supply power to the unit via the provided AC adapter. Do not use other power sources.

•During recording or playback, please do not unplug the DC or power cord.

CONNECTING WITH A SINGLE CAMERA

Please set the MULTIPLEXER option to OFF on the REC SETTING page in the setup menu when it is connected with a single camera. (Please refer to section 5.1 MULTIPLEXER option)

Camera
			SD Card
VIDEO	FROM MUX
	MAIN MONITOR
		AUDIO	RS-485
	IN	IN
		ETHERNET	RS-232
		10/100
OUT		OUT
TO	TO		ALARM	I/O	DC12V
MUX'S VCR IN	MONITOR

Monitor

CONNECTING WITH A MULTIPLEXER

To match the multiplexer’s recording speed, please set the MULTIPLEXER option to ON on the REC SETTING page in the setup menu when it is connected with a multiplexer. (Please refer to section 5.1 MULTIPLEXER option)

Caution: Some multiplexers may cause non-updated playback output. In such a case, please set recording rate at 60 F/S or 20 F/S.

14 15