K-Tec MT2000 manual Table Of Contents

TABLE OF CONTENTS

1.	INTRODUCTION			4
2. OVERVIEW				5
	2.1 Storage Information			5
	2.2	Ambient Temperature		5
	2.3	Description & Principle of Operation		5
		2.3.1	Direct Reflect Mode (standard)	5
		2.3.2	Ultra Low Dielectric (ULD) Measure Method	6
3.	INSTALLATION			7
	3.1	Mounting Requirements		7
	3.2	Shortening of Probe		8
	3.3	MT2000 Guided Wave Radar Guidelines		8
	3.4	Wiring		9
	3.5	ATEX Approval Information		9
4. COMMISSIONING				9
	4.1	Quickstart Procedure		9
	4.2	Verify Proper Power-Up		10
	4.3	Setting the 4mA and 20mA Points Using the Pushbutton Menu		10
		4.3.1 LCD Menu Operation		11
	4.4	Detailed Configuration Parameters		12
		4.4.1	Direct Mode Blanking Parameter (BLK)	12
		4.4.2	Threshold Level Parameter (THV) and Gain Setting (GS)	12
		4.4.3	Advanced Parameter Settings	13
		4.4.4	Ultra Low Dielectric (ULD) Mode Configuration	15
	4.5	Advanced Output Configuration		16
		4.5.1 DAC Trim		16
		4.5.2	Setting the DAC Trim	16
		4.5.3	Displayed Engineering Units (EUN)	16
		4.5.4 4 - 20 mA Output Damping (DMP)		16
		4.5.5 Bench Calibration of the 4mA & 20mA Points		17
		4.5.6	4mA & 20mA Calibration Using Actual Level Input	17
		4.5.7	Reversing the Output Action Using Actual Level Input	18
		4.5.8	Jumper Switch Settings	18
5. TROUBLESHOOTING INFORMATION				19
	5.1	Valid Current Loop Outputs		19
	5.2	Possible Symptoms		19
	5.3	Electronics Module Replacement		20
6. HONEYWELL DE OUTPUT OPTION				20
	6.1	Interoperability and Conformance Class		20
	6.2	Operating Modes		21
7. HART PROTOCOL INTERFACE OPTION				21
	7.1	268 ROSEMOUNT Communicator		21
	7.2	HART AMS		21
		7.2.1	Compatibility	21
		7.2.2	Resource Files	21
8. GLOSSARY OF TERMS				22

2 MT2000-0200-01 Rev f (10-2007) DCN0160