K-Tec MT2000 manual Glossary of Terms, Lrv

8. GLOSSARY OF TERMS

EU	Engineering Units
	Display units selection (inches, mm, feet, %, etc.)
URV	Upper Range Value
	Location on the transmitter sensor to set as the 20 mA output
LRV	Lower Range Value
	Location on the transmitter sensor to set as the 4 mA output
K0	Electronic Module Offset
	Calibration data for each unique electronics module for the MT2000
KG	Electronic Module Gain
	Calibration data for each unique electronics module for the MT2000
BLK	Blanking
	Area at the top of the probe that you do not want monitored for process signal return. Usually increased by a value
	of 4 per inch of nozzle.
	Default factory value of 210.
THV	Threshold Voltage
	Minimum value that the return pulse voltage must be to indicate to the electronics it is a real value. Typical factory
	value to 1.5.
GS	Gain
	One of four different values (1,2,3,4) which tell the electronics which algorithm to use in determining the value of the
	return pulse.
HTP	High Trim Point
	Reference point near the area at which the high Engineering Units value for the transmitter will be set. To be set
	prior to LRV and URV.
LTP	Low Trim Point
	Reference point near the area at which the low Engineering Units value for the transmitter will be set. To be set
	prior to LRV and URV.
ULD	Ultra-Low Dielectric Mode
	Method of operation of the MT2000 that allows its use in situations where there is no detectable signal along the
	length of the probe. Typically used in solids with a DC above 1.3 and below 2.0.
LT	Linearization Table
	Twenty step table inside the MT2000 electronics which can be used to correct the raw signal in situations where the
	output is not linear
	Stilling Well
	Metallic Sleeve that the MT2000 probe is inserted inside. Allows probe to be used in lower DC and in situations
	where there is significant turbulence.
	Coax Probe
	Probe style similar to the MT2000 installed in a Probe Well but with a much smaller diameter pipe. Can be inserted
	through a ¾” NPT fitting. Typically used on very clean fluids or compressed gas products.

22 MT2000-0200-01 Rev f (10-2007) DCN0160