Setting Surface Controls
Operating Single Radiant Surface Elements
The cooktop hassingle radiant surface elements at location as shown on figure 2.
To Operate the Single Surface Elements
1. Place correctly sizedcookware on the radiantsurface element.
2. Push inand turnthe surface control knob ineither direction to the desired setting
(Figure 1). Turn the knob to adjust the setting ifdesired. Start most cooking
operations on a higher setting and then turn to a lower setting to finishcooking.
Each surface element provides a constant amount of heat at each setting. A
glowing red surface heating area extending beyond the bottom edge of the
cookware indicates the cookware is too small for the surface heating area.
3. When cooking has completed, turn the surface control knob to OFF before
removing the cookware. Note: The specific Hot Surface Indicator lightfor the
element willcome on when the control knob is turned on. The light will continue to
glow until the glass cooktop is cooled enough totouch. The light may remain on
even though the controls are turned OFF. Note: See Figure 2 on page 7 for
recommended controlsettings.
Lo
1
2
3
4
Off
5
Figure 1
Hi
9
8
7
6
Operating the Dual Surface Radiant Element
The range is equipped with a dual radiant surface element
located at the rightfront (See Figure 3) position. Symbols on
thecontrol panel are used to indicate which coil of the dual
radiant element willheat. The @symbol indicates that only
the inner coil will heat (Figures 3, 4 and 5). TheO symbol
indicates that both inner and outer coils will heat (Figures 6, 7
and 8). You may switch from either coil setting atany time
during cooking.
To Operate the Dual Surface Element
1. Place correctly sizedcookware on the dual surface
element.
2. Push in and turn the control knob counterclockwise (See
Figure 2) for smaller cookware or clockwise (See Figure
7) for larger cookware.
3. Turn the knob to adjust the setting if needed. Start most
cooking operations on a higher setting and then turn to a
lower setting to finish cooking. Each surface element
provides a constant amount of heat at each setting. A
glowing red surface heating area extending beyond the
bottom edge of the cookware indicates the cookware is
too small for the surface heating area.
4. When cooking has completed, turn the surface control
Inner
Element
®Figure 3
Inner
Element
Off ®
Lo
2
Inner
+Outer
2
4
6
8
4
6
8
Hi Hi
Figure 4
Figure 2
Inner
+Outer
Figure 6
Inner
+Outer
•Off
Lo
2
8 8
Hi Hi
Figure 7
Figure 5 Figure 8
Inner
Element
®
Lo2
knob to OFF before removing the cookware. Note: The specific Hot Surface Indicator lightfor the element will come
on when thecontrol knobis turnedon. The lightwill continue to glow until the glass cooktop is coolenough to touch.
The light may remain on even though the controls are turned OFF. Note: See page 7, Figure 2for recommended
controlsettings.
Radiant surface elements may appear to have cooled after they have been turned off. Ahot surface
indicator light will come onand willcontinue to glow until the glass cooktop has cooled down to a moderate level. The
glass surface may still be hot and burns may occur ifthe glass surface is touched before the indicator lighthas turned
off.
rt_ Do not place plastic items suchas salt and pepper shakers, spoon holders or plastic wrappings on
top of the range when it is in use. These itemscould melt or ignite. Potholders, towels or wooden spoons could catch
fire if placed too close to the surface elements.
10