Setting Oven Controls

Setting the Clock

The @ pad isused to set the clock, The clock may be set for12 or24 hourtime ofday
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash with "PF" (power failure, See Figure 1).
When PF appears in the display, press ("_-_, PF will disappear.
INSTRUCTIONS PRESS
To set the clock (example below for 1:30)
1. Press @. "CLO" will appear in the display (Figure 2).
2. Press Q Q Q pads to set the time of day to 1:30
(Figure 3). "CLO" will stay in the display. Press _. "CLO"
will disappear and the clock will start (Figure 4).

Changing between 12 or 24 hour time of day display

1. Press and hold@ for 7seconds. "CLO" will appear inthe
display. After 3 seconds I_1will appear in the display indicating
that the cooktop lockout is active (Figure 5). CONTINUE
holding the pad until "12h" (Figure 6) or "24h" (Figure 7)
appears in the display and the control beeps once.
2. Press _ to switch between the 12and 24 hour time of day
display. The display will show either "12h" (Figure 6) or "24h"
(Figure 7).
3. Press _ to accept the change or press _'_o_ toreject the
change. I_1will disappear from the display.
4. Reset the correct time as described in To set the Clock
above. Please note that ifthe 24 hour time ofday mode was
chosen, the clock will now display time from 0:00 through
23:59 hours.
(@
for 7 seconds
@

O

Figure 1
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Ill
:Z
15