KRF-V9300D and KRF-V8300D Speaker setup –"Auto Setup"(Auto Room EQ)–
If a message is displayed
If an error or a confirmation message is displayed and measurement is stopped in the middle, a trouble may be detected during the measurement. Read the message and take the proper measure before retrying measurement.
Error message: | Take the measure according to the |
| message and retry measurement. |
Confirmation message: | Check the message content. The |
| operation can be continued without |
| retrying measurement. |
Error messages
"E1 : No Mic" :
The setup microphone is not connected.
➡Connect the provided setup microphone to the [AUTO ROOM EQ MIC IN] jack.
"E2 : Phones" :
Headphones are connected.
➡Unplug the headphones.
Setup
"E3 : No Sp L/R" / "E3 : No Sp L" :
One or both of the front speakers are not connected.
➡Connect the front speakers properly.
"E3 : No Sp SL" / "E3 : No Sp SR" :
One of the surround speakers is not connected.
➡Connect the surround speakers properly.
"E3 : No Sp SBL" :
One of the surround back speakers is not connected.
➡If the system is a
If it is a
"E3 : SB w/o S" :
The surround left and right speakers are not connected.
➡Connect the surround left and right speakers properly.
"E4 : Noisy" :
The measurement environment is too noisy.
➡Remove the cause of noise before retrying measurement.
"E5 : Bad S/N" :
The measurement environment is too noisy.
➡Retry measurement. Do not control the speaker volume during measurement.
"E6 : Far SP" :
The speaker is installed too apart.
➡Reinstall the speaker.
"E7 : DSP" :
A communication error occurred inside the unit.
➡Retry measurement. If the same error message reappears, contact your nearest Kenwood service counter.
"E8 : Time Out" :
The measurement took too long time due to a certain cause.
➡Retry measurement. If the same error message reappears, contact your nearest Kenwood service counter.
34