Kenwood KRF-V7300D, KRF-V8300D, KRF-V9300D Speaker level –"SPLevel"–, Speaker Distance –"SPDistance"–, "L, "C, "R, "SR, "SB, "SL, "SW, "SBR, "SBL, played, [SETUP], [ENTER], [ENTER], Display, Setting

Speaker level –"SP Level"–

Adjust the volume levels of the speakers so that all of them are approximately identical.

1Select "SP Level".

[SETUP]

[MULTI CONTROL 2/3]

[ENTER]

2Select the test tone output method.

[MULTI CONTROL 2/3]

[ENTER]

Display	Setting
"T.TONE Auto"	The test tone is heard from the speakers one after another with
	2 seconds each.
"T.TONE Manu"	You can select the speaker channel from which the test tone
	is output.
"T.TONE Off"	The speaker levels can be adjusted using the sound being
	played.
"Return"	Returns to Setup Menu.

3Adjust the volume level of each speaker.If you select "T.TONE Auto" :

When you hear the test tone from the speaker which you wish to adjust, use [MULTI CONTROL ∞/5] and adjust the volume of the test tone. When you finish adjusting, press [ENTER].

If you select "T.TONE Manu" or "T.TONE Off" :

Use [MULTI CONTROL 2/3] to select the speaker channel to be adjusted, and then use [MULTI CONTROL ∞/5] to adjust its volume level. After adjusting the levels of all the speaker channels, press [ENTER] to enter the settings.

•If you have a commercially available acoustic pressure meter, set the meter-reading unit to "C" and adjust the speaker channel levels so that the noise level is 75 dB. The adjustment should be performed in the listening position.

Speaker Distance –"SP Distance"–

Sets the distance between each speaker and the listening position. The actual distances should be measured before starting this setup.

Distances of speakers

Speaker	Input channel	Distance from the
	indicator	listening position
Front speaker (left)	"L"	meters (feet)
Center speaker	"C"	meters (feet)
Front speaker (right)	"R"	meters (feet)
Surround speaker (right)	"SR"	meters (feet)
			Setup
Surround Back speaker	"SB"	meters (feet)
Surround Back speaker (right)	"SBR"	meters (feet)
Surround Back speaker (left)	"SBL"	meters (feet)
Surround speaker (left)	"SL"	meters (feet)
Subwoofer	"SW"	meters (feet)

1Select "SP Distance".

[SETUP]

[MULTI CONTROL 2/3]

[ENTER]

2Select the unit of distance.

[MULTI CONTROL 2/3]

[ENTER]

Display	Setting
"UNIT Meters"	Measurement in meters.
"UNIT Feet"	Measurement in feet.
"Return"	Returns to Setup Menu.

3Set the distance.Refer to the table above for the distance from each speaker to this unit.

Use [MULTI CONTROL 2/3] to select the speaker.

Use [MULTI CONTROL ∞/5] to set the distance.

The distance can be set in the range of 0.03 to 9.0 meters (0.1 to 30.0 ft) in 0.03-meter (0.1-feet) increments.

4Repeat step 3 for each speaker until the distances of all speakers are set.5Press [ENTER] to enter the setting.

English 37