Kenwood KRF-V7300D, KRF-V8300D, KRF-V9300D Recording mode setting in digital audio source recording, Recording audio (analog sources), Recording video, off, Auto, Manual, Display, "RecMode, "RecMode

Recording mode setting in digital audio source recording

¶ Operation available only on the main unit of this unit. For "M-REC" mode:

When recording a multi-channel digital audio source, it is recommended to set up the recording mode properly to convert the digital input into the 2-channel analog output. Usually use the "A-REC" (Auto record) mode.

However, some discs often produce sound skipping. The "M-REC" (Manual record) mode should be used with such a disc.

4 Start playback, then start recording.

If the audio reproduction stops in the middle due to change in the input signals, etc., press [AUTO/MONO].

AUTO/MONO INPUT SELECTOR	• Recording mode cannot be set when HDMI is enabled. (See
	<HDMI input setup –"HDMI Input"–> ‚.)

Recording

1Use [INPUT SELECTOR] to select the digital input source you want to record.

The digital input source refers to the source input into the digital input terminals (optical and coaxial) on the rear panel. The input at the CD (ASSIGNABLE) terminal follows

the input assignment setup. (See <Input assignment –"Assignment"–> ·.)2Set the MD or TAPE recorder to record.3Press and hold [AUTO/MONO] for more than 2 seconds to select a recording mode.

Recording mode	Display	Operation
Recording mode off	"RecMode Off"	The digital input record mode is switched
		off.
		The digital input signals (DTS, Dolby Digital,
Auto record mode	"RecMode	or PCM) are identified automatically and
	Auto"	converted into stereo signals that are ready
		for recording.
		The digital input signal type at the moment
Manual record mode	"RecMode	this mode is selected is held throughout
		this mode, and the signal is converted into
	Manual"
		stereo signals. But once the digital signal is
		changed to other signal, no signal is output.

When the "A-REC" mode is selected, the digital input signal is converted to stereo signals even if the digital signal is changed.

When the digital mode changes during recording in the "A-REC" mode, the audio input source may be interrupted momentarily.

For "A-REC" mode:

Recording audio (analog sources)

1Use [INPUT SELECTOR] to select the source (other than "MD/TAPE") you want to record.

2Set the MD or TAPE recorder to record.

3Start playback, then start recording.

Recording video

1Use [INPUT SELECTOR] to select the video source (other than "VIDEO1") you want to record.

2Set the video recorder component connected to VIDEO 1 to record.

Select the recording mode to record a digital input source. See <Recording mode setting in digital audio source recording>.

3Start playback, then start recording.

•Recording may not be normal for some video software. This is due to the copy guard condition.

60 KRF-V9300D/KRF-V8300D/KRF-V7300D