KRF-V9300D
Switching the video resolution
¶Operation available only on the remote control unit.Press to select the resolution of the HDMI video output as a result of conversion of an analog video signal.
Checking the HDMI audio input signal which output from the connected component
¶Operation available only on the remote control unit.
The type and number of channels of the audio signal input at the HDMI input can be checked.
RESOLUTION 1Press [RESOLUTION] to select the resolution.Each press switches the setting as follows.
•The available resolution values vary depending on the connected TV monitor.
Display | Setting | |
"RES Auto" | The resolution is set automatically according to | |
the connected TV monitor. | ||
| ||
"RES 1080p" | 1920 x 1080p | |
"RES 720p" | 1280 x 720p | |
"RES 1080i" | 1920 x 1080i | |
"RES 480p/576p" | 720 x 480p, 720 x 576p |
DISPLAY1 Press [DISPLAY].
The type and number of channels of the HDMI input signal | ormusicPlaying | |
are displayed for a few seconds. | ||
| ||
Example: Display with |
| |
input |
| |
• There are some video contents which have more audio signals | movie | |
| ||
recoreded than the input channel indicator on this unit are |
| |
shown. This is because at the recording studio the audio |
| |
sometime is produced with a different speaker configuration |
| |
from the standard speaker configuration. |
| |
In this case, the input channel indicator only shows the channels |
| |
which are the same as the standard speaker configuration, and |
| |
display shows the total number of channels recored in the video |
| |
contents. |
| |
Example: Total number of channels is 7.1ch and the input channel |
| |
indicator is showing 5.1ch |
|
Input channel indicator | Total number of channels |
•Even in the case above, the optimum playback is perfomed according to the speaker setup (speaker
English 47