Kenwood TK-270G, TK-260G service manual Clone Mode, Function

TK-260G/270G

REALIGNMENT

9.If you want to continue programming other TK-260G/ 270Gs, repeat steps 5 to 8.

Notes:

●To start the Firmware Programmer from KPG-56D, the Fpro path must be set up by the KPG-56D Setup.

●This mode cannot be entered if the Firmware Programming mode is set to Disable in the Programming software (KPG- 56D).

●When programming the firmware, it is recommend to copy the data from the floppy disk to your hard disk before you update the radio firmware.

Directly copying from the floppy disk to the radio may not work because the access speed is too slow.

Note: You can clone the programmed data between the tramsceiver listed below.

Frequency version must be same.

Slave TK-260G		TK-260G	TK-760G	TK-760G
	K	M	K	M
Master	TK-270G TK-270G		TK-762G	TK-762G
	K	M	K	M
TK-270G
K

TK-270G

M

Cloning cable parts No.

E30-3410-05 (TK-270G➝TK-260G/270G)

6-4. Function

1.If you press the [MON] switch while "PROGXXX" is displayed, the checksum is displayed. If you press the [MON] switch again (while the checksum is displayed), "PROGXXX" is redisplayed.

2.A transmission speed can be selected by pressing the [LAMP] switch while "PROGXXX" is displayed.

12900 bps: The LED flashes green and red alternately.

38400 bps: The LED flashes orange.

57600 bps: The LED lights orange.

Note:

Normally, write in the high-speed mode.

7. Clone Mode

Programming data can be transferred from one radio to another by connecting them via their SP/MIC connectors. The operation is as follows (the transmit radio is the master and the receive radio is the slave).

1.Turn the master TK-270G power ON with the [LAMP]+[3] keys held down. The TK-270G displays "CLONE".

2.Power on the slave TK-260G/270G.

3.Connect the cloning cable to the SP/MIC connectors on the master and slave.

4.Press the [°] key on the master while the master displays "CLONE". The data of the master is sent to the slave. While the slave is receiving the data, "-PC-" is displayed.

When cloning of data is completed, the master displays "END", and the slave automatically oprates in the User mode. The slave can then be operated by the same program as the master.

5.The other slave can be continuously cloned. When the [°] key on the master is pressed while the master displays

"END", and the slave the master displays "CLONE". Carry out the operation in steps 2 to 4.

PTT/RXD	GND
	REMOTE/TXD
	2.5	2.5
	3.5	3.5

E30-3411-05 (TK-270G➝TK-760G/762G)

	1	MBL
		PSB
		GND
PTT/RXD	GND	PTT/RXD
		ME
	REMOTE/TXD
		MIC
		REMOTE/TXD
	8	CM

8

1

Cloning cable

Fig. 2

10