Kenwood TK-260G Display TK-270Gonly, Scan Operating TK-270Gonly, Icon, Description, Scan types

TK-260G/270G

OPERATING FEATURES

9)Reverse (REV) (Note: C type only)

When the REV switch is pressed, transmission can be performed with the receive frequency and receive signaling, and reception can be performed with the transmit frequency and transmit signaling.

When REV is on, HORN ALERT and PUBLIC ADDRESS do not work.

10)Selectable QT (SEL QT) (TK-270G M types only) When the SEL QT switch is pressed, QT frequency can be temporarily changed with the CH switch.

11)2-Tone Encode Select (TK-270G only)

1Press the key programmed as 2-tone Encode Select.

•A pre-programmed 2-tone code name appears on the display.

2Press the key programmed as Channel Up and Channel

Down to select you desired 2-tone code name.

3Press PTT switch and 2-Tone Encode Select key to transmit and release them to receive.

Note:

The code for the TK-260G is not selectable.

You cannot change the tone in step 2 by using the Channel Up and Channel Down keys.

12) Redial (TK-270G only)

Pressing this key when Group/Channel is shown, displays the previously transmitted DTMF code. Pressing [PTT] at this time, transmits the code that is currently displayed.

13) RF power low

Used to temporarily switch transmission output to low power. Turning the function on enables:

Hi→Low, Low→Low

Key states are backed up, except in the PC mode when they are reset.

14) Scan (TK-270G only)

Pressing this key starts scanning. Pressing this key again stops scanning.

15) Scan Del/Add (TK-270G only)

This key switches the currently displayed channel between "Delete" and "Add".

The "Add" channel is contained in the scan sequence, the "Delete" channel is not contained. In the scan mode, this key switches the channel between delete or add, temporarily.

16) Talk Around (TK-270G only)

Press this key, the transceiver uses the receive frequency and tone for transmission.

The operator can call the other party directly (without repeater). Press this key again, the talk around function goes off.

3. Display (TK-270G only)

Icon Description

Not used in this transceiver.

Appears when the selected channel is busy.

Appears when QT, DQT, DTFM, or 2- Tone decoding is deactivated (by pressing the Monitor key).

Appears when you receive a Code Squelch, Selective Call, 2-Tone, or DTMF Signallling call. Also appears when you transmit using Code Squelch or Selective Call.

Appears while scanning.

Appears when using low power on the selected channel.

Appears when the selected channel is included in the scanning sequence.

Displays the selected channel, the squelch level, DTMF digits (when entering digits, confirming digits, or making a call), and messages received via Selective Call.

4. Scan Operating (TK-270G only)

1) Scan types

●Single Group Scan

You can scan all valid (ADD) channels in the displayed group

that can be selected with the group selector.

●Multiple Group Scan

You can scan all valid (ADD) channels in all valid (ADD)

groups.

2) Scan Start Condition

One or more non-priority channels must be added to all channels that can be scanned. The transceiver must be in normal receive mode (PTT off).

When you activate the key programmed to the scan function, scan starts. The scan icon ("SCN") lights and "SCAN" is indicated on display.

17) None

An error operation beep sounds, and no action will occur. Use this function when the transceiver is required to be operated more simply.

5