KNS3250/R Users Guide - Rev. A00 Kingston Technology Company
Hardware Installation 7

Full Duplex and Collision LED

The FDX/COLL LED uses a single color LED to display two functions. A solid
green light indicates that Full-Duplex operation has been detected. A ashing
amber light indicates that a collision has occurred in half-duplex mode. Full-
Duplex mode is auto-negotiated on all UTP ports.

Fiber FX module port (optional)

The ber FX module port can be used with an optional MT-RJ, ST, or SC ber
module. Port 1 & 2 on the switch are associated with this module. If the optional
module is used, then port 1 & 2 on the switch can not be used. For more details on
the modules and instructions on installing them, please refer to Appendix D - Fiber
FX Modules and installation.

10/100TX UTP Ports

The Fast EtheRx Switch has 16, 24, or 32 (depending on model) UTP ports that
auto-negotiate both 100BASE-TX and 10BASE-T connections, as well as half- or
full-duplex operation.
Rear Panel
100-240VAC
50-60Hz
.07AMAX
CONFIGURATIONPORT
ConfigurationPort ACPower Connector
Fig.3 - Rear Panel

AC Power Connector

The Fast EtheRx Switch uses a 100-240VAC internal power supply. Connect the
AC power cord from the back of the unit to an AC electrical outlet.

Conguration Port

The Fast EtheRx Switch can be managed using the Kingston Switch Conguration
Utility by connecting the conguration cable from the Conguration Port to the
parallel port on the back of your host computer.