Assembling Your Bowl-Lift Mixer
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
To Attach Bowl
1.Be sure speed control is OFF and stand mixer is unplugged.
2.Place bowl lift handle in down position.
3.Fit bowl supports over locating pins.
4.Press down on back of bowl until bowl pin snaps into spring latch.
5.Raise bowl before mixing.
6.Plug into a grounded 3 prong outlet.
RAISE
To Raise Bowl
1.Rotate handle to
2.Bowl must always be in raised, locked position when mixing.
To Lower Bowl
1.Rotate handle back and down.
To Remove Bowl
1.Be sure speed control is OFF and stand mixer is unplugged.
2.Place bowl lift handle in down position.
3.Remove flat beater, wire whip, or dough hook.
4.Grasp bowl handle and lift straight up and off locating pins.
To Attach Flat Beater, Wire Whip, or Dough Hook
1.Turn speed control to OFF and unplug.
2.Slip flat beater on beater shaft and press upward as far as possible.
3.Turn beater to 
right, hooking |
|
beater over |
|
the pin on | PIN |
shaft. |
|
4.Plug into a grounded 3 prong outlet.
To Remove Flat Beater, Wire Whip, Or Dough Hook
1.Turn speed control to OFF and unplug.
2.Press beater upward as far as possible and turn left.
3.Pull beater from beater shaft.
Solid State Speed Control |
| ||||
Off | Stir |
| 2 4 6 8 10 |
| |
|
|
|
|
|
|
|
|
|
|
|
|
Household stand mixer SPEED Control
Plug into a grounded 3 prong outlet. Speed control lever should always to be set on lowest speed for starting, then gradually moved to desired higher speed to avoid splashing ingredients out of bowl. See “Speed Control Guide” section.
9
