You can set up the
1.Press and hold the Shift key and the Paper Selection key.
2.Select U2 in the User mode.
3.Press the Exposure Mode key to display d*. The table below shows the amount of correction based on the setting value:
Code | Setting Value |
d0 | 0 mm |
|
|
d1 | 0.5 mm |
|
|
d2 | 1.0 mm |
|
|
d3 | 1.5 mm |
|
|
d4 | 2.0 mm |
|
|
d5 | 2.5 mm |
|
|
d6 | 3.0 mm |
|
|
d7 | 3.5 mm |
|
|
d8 | 4.0 mm |
|
|
4.Press the Exposure Adjustment key (Darker or Lighter) to select the desired setting value.
5.Press the Start key to validate the setting.
NOTE: This setting returns to the default value (d3) when the Power switch is turned off. You can register this setting by using the Job Program function.