SCSI interface device ID | When you have several devices on a SCSI chain, you may need to adjust the SCSI |
| ID selector on the scanner. This selector assigns a specific device ID to the scanner. |
| If the assignment conflicts with an existing SCSI device, select a new ID. |
| NOTE: The factory setting for the scanner is ID 6. ID 0 is usually assigned to an |
| internal hard disk drive and ID 7, ID 8, and ID 9 are not in actual use. The |
| scanner will not operate properly if the SCSI ID is set to ID 7, ID 8, or ID 9. |
| • Using a suitable tool, turn the SCSI ID selector switch until the arrow points to the |
| desired ID number. |
Setting the SCSI terminator
SCSI ID selector
SCSI terminator switch
The scanner comes with a
•If the scanner is the only or the last device in a SCSI chain, place the terminator switch in the ON position.
•If the scanner is to be located between the computer and another SCSI device, place the terminator switch in the OFF position.
7 |
