Kodak i60, i50 manual Replacing the ADF snap-in feed module, ADF Upper part of ADF pad clamp

Replacing the ADF snap-in feed module

After approximately 100,000 pages have been scanned through the ADF, the separation pad may become worn and cause document feeding problems. In this case, you should replace the feed module.

Four replacement ADF snap-in feed modules are included with your scanner. To order more feed modules, consult your dealer or order online at www.kodak.com/go/shop (order KODAK Feed Module for Scanners i50/i60; catalog number 181-4300.)

Follow the procedure below to replace the feed module.

1.Open the ADF.

2.Remove the ADF snap-in feed module by pinching the gray tabs.

3.Pull out the upper part of the pad clamp.

ADF

Upper part of

ADF pad clamp

4.Take the ADF feed module out of its box.

5.Hold the upper part of the pad clamp and place it on the pad holder.

ADF feed module

Upper part of

ADF pad clamp

6.Close the ADF.

The scanner is now ready for use.

A-61182 October 2001 29