Adjust the Water Temperature (cont.)
Rotate and reposition the limit stop on the handle splines. Rotating the limit stop clockwise toward the back of the faucet will decrease the maximum temperature limit. Each spline represents approximately 10°F (5°C) change in temperature.
Reinstall the handle vertically with the limit stop in place. Do not secure the handle with the screw at this time.
Turn the handle to full hot and check the water temperature.
Repeat the above procedures until the desired temperature is reached.
Secure the handle assembly with the screw.
Remove the cleaning strap and turn on the water.
For Vandal-Resistant Installations
NOTE: If you install the
Using the handle, adjust the water to the desired temperature.
Remove the handle screw using the supplied 2.5 mm hex wrench.
Position the
Kohler Co. | 5 |