Kohler k-10950, k-10951 manual Convert to Tempered Water, Service the Battery cont

Service the Battery (cont.)

Reinstall the battery clip inside the faucet body.

NOTE: ″Connector Position 1″ is the preferred installation location for the connectors. ″Connector Position 2″ may also be used as an alternate installation location. Refer to the above illustration.

Position the connector tight to the battery clip in connector position 1 (DC models have one connector).

Slide the faucet spout over the valve assembly. It is important that the front of the spout line up with the pin at the bottom front of the valve assembly.

IMPORTANT! Verify that all the wires are inside the faucet body and are not pinched.

Convert to Tempered Water

To provide tempered water only, use a wrench to remove the hose for the hot water after first turning off the water supply to the faucet.

Replace the hose with the plug supplied and securely wrench tighten.

If applicable, install the vandal-resistant plug button. Refer to the ″Disassemble the Faucet″ section to remove the handle.

Turn on the water supply to the faucet and check for leaks.

1025498-5-H 8 Kohler Co.