Sensor Clip
2
1
Connector
Position 2
Sensor | Connector | ||
Position 1 | |||
|
| ||
Battery Clip | Battery Clip |
| |
Installation | Installed |
|
Replace the Sensor
CAUTION: Risk of product damage. Do not disconnect the connectors by pulling on the wires.
Carefully disconnect the wires by pulling gently on the connectors.
Pull the loop outward to disengage the clip from the groove.
Rotate the clip counterclockwise.
Remove the old sensor.
Attach the new sensor wires to the connectors.
Install the sensor in the faucet, wire side first.
Align the sensor eyes with the holes in the spout.
Place the straight end of the clip into the hole in the retaining wall of the spout.
Pull the clip out until the bend in the clip is resting at the entrance to the groove. Avoid pinching the wires between the sensor and clip.
Push the clip in until it is firmly seated in the groove.
Kohler Co. | 9 |