Kohler k-10950, k-10951 manual Service the Diaphragm, Service the Plug

Plug

Diaphragm

Assembly

O-Ring

Faceplate

Screw

Service the Diaphragm

NOTE: Disassemble the faucet following the steps in the ″Disassemble the Faucet″ section.

Disconnect the wire connectors and set the faucet body aside.

Using a Phillips screwdriver, remove the four screws.

Check the O-ring for wear. Replace if worn.

Remove the diaphragm from the back of the faceplate by gently prying it away with your fingers.

Rinse off any debris.

Position the replacement diaphragm and snap it into place.

Reinstall the faceplate and secure with the four screws.

Proceed to the ″Reassemble the Faucet″ section.

Service the Plug

NOTE: Disassemble the faucet following the steps in the ″Disassemble the Faucet″ section.

Disconnect the wire connectors and set the faucet body aside.

Use a hex wrench to remove the plug.

Install the replacement plug assembly and securely wrench tighten.

Proceed to the ″Reassemble the Faucet″ section.

1025498-5-H 12 Kohler Co.