Korg MICRO manual Pitch SYNTH/VOCODER

2.PITCH — SYNTH/VOCODER

These settings specify the pitch of the oscillator.

Use "TRANSPOSE" (knob 1) and "TUNE" (knob 2) to set the desired pitch. These settings are shared by oscillators 1 and 2. In this section you can also set the portamento time, and specify how the PITCH and MOD wheels will affect the pitch.

TRANSPOSE		[-24...24]	TUNE	[-50...50]	PORTAMENTO	[0...127]
Adjusts the pitch of the oscillator in			Adjusts the pitch of the oscillator in		Specifies the speed of the
semitone (100 cent) steps.			one-cent steps.		portamento effect (a smooth change
The range is two octaves upward or					in pitch from one note to the next
downward.					note of a different pitch).
	Changes made by the front				With a setting of 0, there will be no
					portamento effect. Increasing this
	panel OCTAVE SHIFT buttons
					value will cause the pitch change to
	actually shift the pitches as-
					occur over a longer time.
	signed to the keyboard (or keys)
					If "VOICE ASSIGN" is set to
	in one-octave steps, and do not
	affect the pitch of the oscillator				Mono or Unison, and if "Trigger"
	that is sounding. Nor are such				is set to Single, portamento will
	settings saved by the Write op-				not apply to the first-sounded
	eration. If you wish to change				note.
	the pitch of the oscillator itself,
	you must use this "TRANS-
	POSE" setting to specify the
	pitch.

BEND RANGE [-12...12]

Specifies the amount of pitch change in semitones that will occur when the pitch wheel is operated. This value specifies the amount of change that will occur when you move the pitch wheel all the way to the away from you.

VIBRATO INT [-63...63]

Specifies the depth of vibrato that will be applied when you move the MOD (modulation) wheel all the way away from yourself.

The LFO2 modulates the pitch of the oscillator, raising and lower- ing it to create vibrato.

17