Korg MICRO manual Timbre SELECT/FORMANT Hold key, Edit Controls 1, 2, 3, 4, 5 knobs

Front and rear panel

TIMBRE SELECT/FORMANT HOLD key	ORIGINAL VALUE LED	EDIT CONTROLS 1, 2, 3, 4, 5 knobs
If a Synth program using "layer" is selected,	This will light if the value of the parameter	These knobs edit the Performance Edit
this key allows you to chose which timbre	currently being edited matches the value that is	parameters or the parameters of the section
will be edited or sounded, or lets you edit	stored in the program. (➝ p.13)	selected by the EDIT SELECT 1 and 2
both timbres simultaneously (Sync).	(This LED does not function for Performance	knobs. (➝ p.8, 9, 10)
If a Vocoder program is selected, this key	Edit.)
switches Formant Hold on, letting you hold
the tone currently produced by the vocoder
without continuing to speak into the mic.
TIMBRE SELECT 1 LED,
TIMBRE SELECT 2 LED
If a Synth program using Layer is selected,
the LED(s) will light to indicate which
timbre(s) will be edited. If a timbre is being
soloed, its LED will blink.
If a Vocoder program is selected, the 1 LED
will light if the formants are being held.
EDIT SELECT 1 dial,
EDIT SELECT 2 dial
These dials select the section to edit.
(➝ p.12)
SYNTH/VOCODER 1 LED,
SYNTH/VOCODER 2 LED
These indicate whether the selected
program is a Synth or a Vocoder program.
If both the SYNTH/VOCODER 1 and 2
LEDs are lit, the Performance Edit function
is enabled.
If only one LED is lit, the EDIT SELECT
knob corresponding to the lit LED will be
the object of your editing. If the object of
editing has not been finalized, the LED will
blink.

Vocoder parameters These are the parameters for a Vocoder program.

Synth parameters These are the parameters for a Synth program.

3