Korg MICRO 20. ARPEG. B

45
Figure 20-1
20. ARPEG. B — SYNTH/VOCODER
LATCH [OFF, ON]
Specifies how the arpeggiator will
operate when you take your hand
off of the keyboard.
OFF ( ):
The arpeggiator will stop playing
when you take your hand off of the
keyboard.
ON ( ):
The arpeggiator will continue play-
ing even if you take your hand off
of the keyboard.
Here you can make additional arpeggio-related settings. "LAST STEP" (knob 4) sets the number of steps in the arpeggio. "LATCH" (knob 1)
specifies how the arpeggiator will operate when you release the keyboard, "SWING" (knob 2) adjusts the sense of swing, and "KEY SYNC"
(knob 3) specifies how the arpeggiator will be synchronized to the keyboard. In addition, "TARGET TIMBRE" (knob 5) specifies which
timbre(s) of a Layer synth program will be sounded by the arpeggiator.
SWING [-100...100]
Specifies the percentage (%) by
which even-numbered notes of the
arpeggio will be shifted in timing
relative to the first note.
(➝Figure 20-1)
KEY SYNC [OFF, ON]
Specifies whether the arpeggiator
will be synchronized to the key-
board.
If this is ON, the arpeggiator will
always start from the beginning of
the arpeggio pattern when you play
the keyboard. If you are perform-
ing together with other instru-
ments, you can use this function to
ensure that the arpeggio pattern is
aligned with the beginning of the
measure.
OFF ( ):
Sync off (not synchronized).
ON ( ):
Sync on (synchronized).
LAST STEP [1...8]
Specifies the number of valid steps
(maximum number of steps) for the
step arpeggiator.
TARGET TIMBRE
[Both, Timbre 1, Timbre 2]
Selects the timbre(s) that will be
sounded by the arpeggiator. This
can be set only for a Layer program.
Both ( ):
Both timbres will be sounded by the
arpeggiator.
Timbre 1 ( ):
Only timbre 1 will be sounded by
the arpeggiator.
Timbre 2 ( ):
Only timbre 2 will be sounded by
the arpeggiator.
When Resolution =1/8
123456789
Swing –50 –25 +25 +50