Effect
213
046: St. Modulation Delay

(Stereo Modulation Delay)

This stereo delay uses an LFO to sweep the delay time. The

pitch also varies. You will obtain a delay sound with swell

and shimmering. You can also control the delay time using a

modulation source.

b: D-mod Modulation
When the modulation source is used for control, this parameter
reverses the left and right modulation direction.
e: LFO Sync, e: Src,
f: L LFO Phase [degree], f: R LFO Phase [degree]
The LFO can be reset via a modulation source.
The “Src” parameter sets the modulation source that resets the
LFO. For example, you can assign Gate as a modulation source so
that the sweep always starts from the specified point.
“L LFO Phase” and “R LFO Phase” set the phase obtained when
the left and right LFOs are reset. In this way, you can create
changes in pitch sweep for the left and right channels individu-
ally.
The effect is off when a value of the modulation source spec-
ified in the “Src” parameter is 63 or smaller, and the effect is
on when the value is 64 or higher. The LFO is triggered and
reset to the “L LFO Phase” and “R LFO Phase” settings
when the value changes from 63 or smaller to 64 or higher.
047: St. Dynamic Delay

(Stereo Dynamic Delay)

This stereo delay controls the level of delay according to the

input signal level. You can use this as a ducking delay that

applies delay to the sound only when you play keys at a high

velocity or only when the volume level is low.

aModulation Mode LFO, D-mod
Switches between LFO modulation control and modulation source
control
b
D-mod Modulation
Reversed L/R control by modulation source L/R:+/+, L/R:+/–
☞,
Src Off...Tempo
Selects the modulation source that controls delay time
Response 0...30
Sets the rate of response to the modulation source
c
LFO Waveform
Selects LFO Waveform Triangle, Sine
LFO Shape –100...+100
Determines how much the LFO waveform is changed ☞ Fx:020
dLFO Frequency [Hz]
Sets the LFO speed 0.02...20.00Hz
e
LFO Sync
Switches LFO reset off/on Off, On
☞,
Src Off...Tempo
Selects the modulation source that resets the LFO
f
L LFO Phase [degree] –180...+180
Sets the phase obtained when the left LFO is reset ☞
R LFO Phase [degree] –180...+180
Sets the phase obtained when the right LFO is reset ☞
g
L Depth
Sets the depth of the left LFO modulation 0...200
R Depth
Sets the depth of the right LFO modulation 0...200
h
L Delay Time [msec]
Sets the left delay time 0.0...500.0
R Delay Time [msec]
Sets the right delay time 0.0...500.0
i
L Feedback
Sets the feedback amount of left delay –100...+100
R Feedback
Sets the feedback amount of right delay –100...+100
j
Wet/Dry –Wet...–1:99, Dry, 1:99...Wet
Sets the balance between the effect and dry sounds
☞ Fx:010,
Src Off...Tempo
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance –100...+100
Left
Right
Feedback
LFO Phase
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
LFO: Tri / Sine
Modulation Mode
D-mod
LFO
D-mod
Delay
Delay
L/R: +/+ +/–
LFO Shape
Response
LFO Sync
a
Control Target
Selects from no control, output, and feedback None, Out, FB
☞
Polarity
Reverses level control +, –
☞
b
Threshold
Sets the level to which the effect is applied 0...100
☞
Offset
Sets the offset of level control 0...100
☞
cAttack
Sets the attack time of level control 1...100
☞
dRelease
Sets the release time of level control 1...100
☞
eL Delay Time [msec]
Sets the delay time for the left channel 0.0...680.0msec
fR Delay Time [msec]
Sets the delay time for the right channel 0.0...680.0msec
gFeedback
Sets the feedback amount –100...+100
h
High Damp [%]
Sets the damping amount in the high range 0...100%
☞ Fx:043
Low Damp [%]
Sets the damping amount in the low range 0...100%
☞ Fx:043
iSpread –100...+100
Sets the width of the stereo image of the effect sound ☞ Fx:043
j
Wet/Dry Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
Src Off...Tempo
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance –100...+100
Delay
Left
Right
Feedback Spread
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
High DampLow Damp
High DampLow Damp
Threshold
+
Delay
FB Out
Control Target
Attack, Release
Envelope