232
Double-size effects
(Available for Insert Effects IFX2, 3, and 4)

090: Piano Body/Damper

(Piano Body/Damper Simulation)

This effect simulates the resonance of the piano sound board
caused by the string vibration, and also simulates the reso-
nance of other strings that are not being played when you
press the damper pedal. It will create a very realistic sound
when applied to acoustic piano sounds.
a: Sound Board DepthThis parameter sets the intensity of resonance of the piano sound board.b: Damper Depth, b: SrcThis parameter sets the resonance intensity of the other strings created when the damper pedal is pressed. The “Src” parameter selects the modulation source from which the damper effect is applied. Usually, select Damper #64 Pdl (Damper pedal).The effect is off when a value for the modulation source specified for the “Src” parameter is 63 or smaller, and the effect is on when the value is 64 or higher.c: Tone, d: Mid ShapeThese parameters control the tonal quality of the effect sound.e: TuneSince this effect simulates the resonance of the strings, the sound varies depending on the pitch. If you have changed tuning using the “Master Tune” (Global P0: 0–1a), adjust this parameter value.

091: St. Mltband Limiter

(Stereo Multiband Limiter)

This is a stereo multiband limiter.

092: OD/HyperGain Wah

(Overdrive/Hyper Gain Wah)

This distortion effect has two modes: overdrive and hyper-
gain that produces a strong distortion. A higher high-gain set-
ting is required for this effect relative to a normal-size effect.
Double Size
aSound Board Depth 0...100
Sets the intensity of resonance of the sound board ☞
b
Damper Depth 0...100
Sets the intensity of the string resonance created when the damper
pedal is pressed ☞,
Src
Selects the modulation source of damper effect Off...Tempo
☞
cTone
Sets tonal quality of effect sound 1...100
☞
dMid Shape
Sets the mid range of tonal quality 0...36
☞
eTune
Fine tuning –50...+50
☞
f
Wet/Dry Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
Src Off...Tempo
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance –100...+100
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
D-mod
Piano
Body/Damper
Simulation
Damper
+
aRatio 1.0:1...50.0:1, Inf:1
Sets the signal compression ratio ☞ Fx:003
bThreshold [dB] –40...0dB
Sets the level above which the compressor is applied ☞ Fx:003
cAttack
Sets the attack time 1...100
☞ Fx:003
dRelease
Sets the release time 1...100
☞ Fx:003
eLow Offset [dB]
Sets the low range gain of trigger signal –40...0dB
☞ Fx:004
fMid Offset [dB]
Sets the mid range gain of trigger signal –40...0dB
☞ Fx:004
gHigh Offset [dB]
Sets the high range gain of trigger signal –40...0dB
☞ Fx:004
h
Gain Adjust [dB] –Inf, –38...+24dB
Sets the output gain ☞ Fx:003,
Src
Selects the modulation source for the output gain Off...Tempo
Amt
Sets the modulation amount of the output gain –63...+63
i
Wet/Dry Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
Src Off...Tempo
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance –100...+100
a
Wah Off, On
Switches Wah on/off ☞ Fx:006,
Src Off...Tempo
Selects the modulation source that switches the Wah on and off
☞ Fx:006
Sw Toggle, Moment
Selects the switching mode for the modulation source that switches
the Wah on and off ☞ Fx:006
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
Gain Adjust
Limiter
Limiter
Limiter
Envelope - Control
Envelope - Control
Envelope - Control
Gain Adjust
Limiter
Limiter
Limiter
Low
Mid
High
Envelope - Control
Envelope - Control
Envelope - Control
Low
Mid
High
Offset
Band-Pass Filters
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+Amp Simulation
4 Band PEQ
Output Level
Direct Mix
Pre Low-cut
D-mod
Wah
Mode: Overdrive / Hyper-Gain
Drive
Driver