Connecting the VP-23RC Presentation Switcher Section

6Connecting the VP-23RC Presentation Switcher Section

To connect1 the VP-23RCPresentation Switcher section, as illustrated in the example in Figure 5, do the following2:

1.Connect the following video sources:

￿One3 composite video source (for example, a composite video player) to the CV IN 1 BNC connector

￿One3 s-Video source (for example, an s-Video player) to the Y/C IN 1 4-pin connector

￿One3 VGA/UXGA source (for example, a computer graphics source) to the UXGA IN 1 15-pin HD connector

2.Connect the acceptors to a projector4 as follows:

￿The composite video CV OUT BNC connector to the composite video input of the projector

￿The s-Video Y/C OUT 4-pin connector to the s-Video input of the projector

￿The VGA/UXGA UXGA OUT 15-pin HD connector to the VGA/UXGA input of the projector

3.Connect the appropriate balanced5 audio sources and acceptors (not shown in Figure 5).

4.If required, connect the MASTER OUT terminal block connector (not shown in Figure 5; see section 9￿ .4.2).

5.Connect the SPKR OUT block connector to a pair of loudspeakers, by connecting the left loudspeaker to the “L+” and the “L-” terminal block connectors, and the right loudspeaker to the “R+” and the “R-” terminal block connectors. Do not Ground the loudspeakers.

6.Connect the UXGA CAT5 OUT twisted pair connector (see section 6￿ .2) to a line receiver (for example, the TP-120XGA Line Receiver6, which is connected to a remote display).

7.If required, connect a dynamic or a condenser microphone7 to the MIC IN XLR connector.

1 You do not need to connect all the inputs

2 Switch OFF the power on each device before connecting it to your VP-23RC. After connecting your VP-23RC, switch on its power and then switch on the power on each device

3 Although in this example only one source is connected, you can connect all of the four inputs, that is, 12 in total

4 In this example a projector is used, but you can also connect separate outputs such as displays or video recorders 5 To connect audio inputs and outputs, see section 6￿ .1

6 The receiver receives the CAT 5 signal, decodes it and outputs it to a VGA acceptor

7 Use the Con / Dyn switch (refer to the rear panel, item 2 in Figure 3) to select a dynamic microphone or a condenser

15

Page 19
Image 19
Kramer Electronics user manual Connecting the VP-23RC Presentation Switcher Section