Connecting to the Media / Room Controller Equipment
19
To connect
1
the VP-23RC Media/Room Controller section, as the example
illustrated in Figure 10 shows, do the following
2
:
1. Connect the RELAY
3
terminal block connectors as follows:
Connect RELAY 1 to the blinds
Connect RELAY 2 to the lighting system
Connect RELAY 3 to the projector lift
Connect RELAY 4 to the screen
2. Connect the IR terminal block connectors
4
, via the Kramer IR Emitter Control
Cable (C-A35/IRE-10)
5
, as follows:
Connect IR 1 to the composite video player (connected
to CV IN 1 on the VP-23RC)
Connect IR 2 to the s-Video player (connected to Y/C
IN 1 on the VP-23RC)
3. Connect the RS-232 port 1 to the projector
6
.
4. Set the PROGRAM dipswitches (see section 7.1).
5. Connect the power cord.
Upon completion of the installation, and before operation, the VP-23RC needs
to be configured by the system integrator (see section 9.2)
1 You do not need to connect all the items
2 Note that Figure 10 emphasizes the connections related to the Media/Room Controller section, other connections are grayed
out
3 On each 3-pole terminal block connector, connect either: C to NO, or C to NC (C is Common, NO is Normally Open and
NC is Normally Closed)
4 VP-23RC has three IR emitters. In this example only two IR emitters are connected
5 Refer to the cables’ user manuals for inst allation instructions. In addition, two IR Emitter Extension Cables are also
available: a 15 meter cable and a 20 meter cable
6 In this example only Port 1 is connected, but you can also connect the RS-232 port 2 to a display or other device (or, if
required, connect it to a PC for firmware upgrade, see section 10.2)