Kramer Electronics VP-23RC Setting the Media / Room Controller Program Dipswitches, Description

Connecting to the Media / Room Controller Equipment

7.1Setting the Media / Room Controller PROGRAM Dipswitches

The PROGRAM dipswitches are located in the CONTROLLER area of the rear panel (see section 7￿ .1). Table 6 defines the PROGRAM dipswitch settings:

Table 6: PROGRAM Dipswitch Settings

DIPS Description

1ON for Firmware Upgrade (see section 10￿ .2)

2Not used

3ON for Factory Reset (see section 7￿ .1.1)

4Not used

7.1.1Factory Reset

Factory reset clears all the button macro configurations1, serial ports definition and also returns the IP number, Gateway and Net mask to their preset default settings2.

Warning: Factory Reset erases all the configured button macros

To reset the Media/Room Controller to its default settings, do the following:

1.Turn the power on the VP-23RCOFF.

2.Set DIP 3 ON.

3.Turn the power on the VP-23RCON.

The machine initializes after about 5 seconds

4.Set DIP 3 OFF.

1 On the Media/Room Controller buttons as well as on the Presentation Switcher SELECTOR buttons 2 IP number: 192.168.1.39, Gateway: 0.0.0.0, and Net mask: 255.255.0.0

21