Connecting the Seamless Switcher / Scaler
5 Connecting the Seamless Switcher / Scaler
Using the
To connect the
1.Connect one or more of the following video sources:
•2 composite video sources, “Composite Video Source 1” and “Composite Video Source 2”, to the RCA connectors CV 1 and CV2, respectively3
•2
•A component video source4, for example, a Betacam VCR (as illustrated
5
in Figure 3), to the 3 RCA connectors, Y, Pb/Cb, and Pr/Cr
•A VGA graphics source, for example, a PC with an analog graphics output, to the VGA HD15F connector
•A DVI graphics source, for example, a PC with a digital graphics output, to the DVI connector
2.Connect the stereo audio sources, as illustrated in Figure 3. In particular:
•The audio of the “Composite Video Source 1” to the AUDIO INPUT VIDEO 1 pair of RCA connectors6
•The audio of the
•The audio of the Component video source, the Betacam VCR, to the AUDIO INPUT COMPONENT pair of RCA connectors
•The audio of the DVI Graphics Source to the AUDIO INPUT PC 3.5mm socket8. Alternatively, connect the audio from the VGA Graphics Source (not illustrated in Figure 3)
1 For details of how to set the output resolution, refer to section 6.1
2 Switch OFF the power on each device before connecting it to your Seamless Switcher / Scaler. After connecting your Seamless Switcher / Scaler, switch on its power and then switch on the power on each device
3 Connection to CV 2 is not shown in the example in Figure 3 4 Sometimes called YUV, or Y,
5 Alternatively, you can connect an RGB signal (not shown in Figure 3), as follows: RED to the “Y” connector, GREEN to the “Pb/Cb” connector, and BLUE to the “Pr/Cr” connector
6 The VIDEO 1 connectors are common to CV 1 and YC 1 7 The VIDEO 2 connectors are common to CV 2 and YC 2 8 The PC connector is common to DVI and VGA
7
