Kramer Electronics VP-719DS user manual H Total

Addendum: Scalers Group

8.Under the Utility>Output Setting>User Mode Setting there is a new option: “Set Current”. This feature lets you apply the parameters of the currently selected output resolution to the User Define output resolution (Utility>Output Setting>Resolution). This set of parameters can be used as a “starting point” to adjust parameters according to the requirements of the signal receiver. The changes to the User Define parameters are applied immediately and require confirmation in the same part of the OSD.

9.In the OSD under UTILITIES>ADVANCED there is new item “User Define Measure”. This feature lets you modify the automatically detected parameters of the input graphic signal and save them in one of 3 sets for further use. The changes are applied in real time and therefore can be monitored directly on the screen. This feature is especially useful in working with non-standard input resolutions. The following parameters can be changed:

H Total:	Horizontal total
H Start:	Horizontal active start point
H Active:	Horizontal active region
V Start:	Vertical active start point
V Active:	Vertical active region
Ch Pump:	Charge Pump current
Color:	Color Format

10.Under the Utility>PIP Setting>PIP Size, there is a new option: “User Define”. This feature lets you set the size of the PIP to your exact needs. To use this option, select “User Define”, then press the “PIP User Define” bar and set the PIP V-size(0-2551) and H-size(0-2551). This option does not apply to the VP-719DS.

11.By pressing the +, -, UP and DOWN buttons continuously, you can speed up their response. For example, to roughly set the brightness to a higher level, open “Brightness and Contrast”>Brightness, and press and hold the + button. For step-by-step response, press and release these buttons as many times as needed.

12.New firmware supports an updated set of RS-232 protocol commands. These commands are available on our Web site at http://www.kramerelectronics.com

13.Under Geometry>Scale>Aspect Ratio there is a new option: “User Define”. This feature lets you adjust the geometry of the outputted picture.

14.A new refresh rate for HDTV resolutions. This new feature supports the HDTV outputs with 50Hz refresh rate2.

1255 corresponds to a full screen

2This option applies to machines that support HDTV resolutions

A2