Krell Industries HTS 2 manual SystemSetup and Configuration, Navigating The Menu

SystemSetup and Configuration

Theremotecontrol is the maininput device for the HomeTheaterStandard.All initial setup and subsequentsystem configuration adjustments must be madethrough the remotecontrol, or via the RS-232port.

For maximumperformance, the HomeTheater Standard must be configured for each systemdevice, its capabilities, andspeakerpositions in the listening room.Krell recommendsconfiguring your system, step-by-step, in sequential order. Enter information into the HomeTheater Standardthrough interactive on-screen menus. Thesemenusare structured to guide you through the setup process for eachdevice or for your entire surround soundsystem.

NAVIGATING THE MENU

To navigate the menu,use the remotecontrol's directional, enter, andprevious keys. The direction keys: ~, 1", ~, and 4, (80) let you movearound the menuscreen and highlight the desired selection (indicated by a blinking cursor). Theenter key (83)

you select the highlighted item. Theprevious key (79) sendsyou to the previous screen. If at any time during the systemconfiguration processyou wish to exit the menusystem, press the remote control menukey (81).

Note

Someoptions in the HomeTheater Standardare designedspecifically for digital and~or analogdevices. To use the digital or analogoptions, you must connectthe correct format device for the desired option.

It is easier to understandthe numerousoptions available to you through the Home Theater Standardif you havea specific configuration example.The following sections illustrate setup andconfiguration by showingyou howto select a DVDdevice, configure available options, andintegrate the device into your system.

ACCESSING THE MAIN MENU

To begin configuring the system:

1.Connectthe on-screen video output of the HomeTheater Standard on the back panel to your video monitor. Set the video monitorto this input.

SeeReadThis First, on page 5, for information on makingthe on-screen display visible on your video monitor.

2.Connectthe ACpower cord to the IEC power connector (55) on the HomeTheater Standardand to the ACwall receptacle.

3.Movethe back panel powerswitch (54) into the up (on) position. The red power on the front panel illuminates. ThewordsPLEASEWAIT,INITIALIZING...appearin the front panel display (23). Whenthe initializing messagedisappears, the HomeTheater Standardis ready to switch to operational mode.

26 Krell HomeTheaterStandard