![](/images/new-backgrounds/1173891/173891169x1.webp)
Using the Operator Panel
NOTE: The RAM disk can not be used when an optional hard disk is installed.
The RAM disk stores data only temporarily. When the printer is reset or turned off, the stored data will be erased.
The RAM disk is allocated within the printer's memory available to users. If the size of the RAM disk is set too large, the printing speed may decrease or the memory may become insufficient.
Setting the RAM Disk Size
1 | Press [MENU]. |
2 | Press U or V repeatedly until RAM Disk |
| Mode appears. |
3 | Press [OK] ([ENTER]). A blinking question |
| mark (?) appears. Press U or V to select |
| On. Press [OK] ([ENTER]). |
4 | Press Z. Press U or V repeatedly until |
| >RAM Disk Size appears. The data size |
| also appears. |
5 | Press [OK] ([ENTER]). A blinking cursor (_) |
| appears. Press U or V to display the |
desired size. Definable RAM disk size is 0001 to 1024.
RAM Disk Mode Off
RAM Disk Mode ? On
>RAM Disk Size 0119 MByte
>RAM Disk Size 0119
MByte
6
7
This range varies depending on the total memory size of the printer. The setting exceeding this range is automatically adjusted to the maximum RAM disk size.
When the desired RAM disk size is displayed, press [OK] ([ENTER]).
Press [MENU]. The display returns to Ready. Turn the printer off and then on again. The selected RAM disk size is activated after the printer is restarted.
ADVANCED OPERATION GUIDE |