Kyocera C5025N manual Memory Card Write Data, Write Data ?, Writing Data

Using the Operator Panel

Writing Data

Data can be written to a memory card until the card is full. When writing to a memory card, a name is assigned to the file automatically. You can use the procedure explained in the section Printing a List of Data Names (Partitions) on page 2-56to print a list of data names for confirmation.

NOTE: First check that the memory card is properly formatted. Otherwise, the >Write Data message to be explained below will not be shown on the message display. If the memory card inserted in the memory card slot is not formatted, >Format will automatically appear on the message display. Format the memory card. See Formatting a Memory Card on page 2-55.

1

2

3

4

Press [MENU].

Press U or V repeatedly until Memory Card > appears.

Press Z.

Press U or V repeatedly until >Write Data appears.

Memory Card >

>Write Data

5	Press [OK] ([ENTER]). A question mark (?)
	appears.

>Write Data ?

6

7

Press [OK] ([ENTER]). Processing appears, then Waiting.

Send the file from the computer to the printer.

As the printer receives data, the message display changes to Processing, then when the end of the data is received, the message display changes to Waiting.

8	Check that the message display has changed to Waiting, then press [GO].
	This writes the file to the memory card and instructs the printer to

automatically print out a memory card write information page as shown below.

The file is written onto the memory card given a destination name (also referred to as a partition name) which the printer automatically assigns one

ADVANCED OPERATION GUIDE 2-53