Lenovo E200 manual Quick and Full erase hard drive, Viewing the test log

can run certain tests in destructive mode (i.e. surface scan tests). Destructive tests will speed up testing because FDAT does not preserve the data on the media prior to the test beginning. Unlike non-destructive tests, any data present on the media prior to the test beginning is lost.

FDAT allows for enabling or disabling destructive tests, as well as specifying a range of destructive and non-destructive sectors on the tested drive. This is done through the configuration of the FDAT.INI. If destructive and non-destructive ranges somehow overlap, then the overlapped area is considered non-destructive. For example, if users specify both destructive and non-destructive ranges as the same, then the entire drive is tested as non-destructive.

Quick and Full erase - hard drive

The diagnostics program offers two hard drive format utilities:

vQuick Erase Hard Drive

vFull Erase Hard Drive

The Quick Erase Hard Drive provides a DOS utility that performs the following:

vDestroys the Master Boot Record (MBR) on the hard drive.

vDestroys all copies of the FAT Table on all partitions (both the master and backup).

vDestroys the partition table.

vProvides messages that warn the user that this is a non-recoverable process.

The Full Erase Hard Drive provides a DOS utility that performs the following:

vPerforms all the steps in Quick Erase.

vProvides a DOS utility that writes random data to all sectors of the hard drive.

vProvides an estimate of time to completion along with a visual representation of completion status.

vProvides messages that warn the user about non-recoverable process.

Important: Make sure that all data is backed up before using the Quick or Full Erase functions.

To select the Quick Erase or Full Erase Hard Drive utility, use the following procedure:

1.Select the UTILITY option on the toolbar and press Enter.

2.Select either the QUICK ERASE or FULL ERASE HARD DISK option and follow the instructions.

Viewing the test log

Errors reported by the diagnostic test will be displayed by the program as a failed test.

To view details of a failure or to view a list of test results, use the following procedure from any test category screen:

1.Press F3 to activate the log file.

2.Press F3 again to save the file to diskette or press F2 to print the file.

Chapter 5. Diagnostics 47