Lenovo E200 manual Installing or replacing a memory module

Installing or replacing a memory module

Attention

Do not open your computer or attempt any repair before reading and understanding the “Important safety information” in the Lenovo 3000 Safety and Warranty Guide that came with your computer. To obtain a copy of the Lenovo 3000 Safety and Warranty Guide, go to: http://www.lenovo.com/support

This section provides instructions on how to install or replace a memory module.

Your computer has two slots for installing or replacing DDR2 DIMMs (double data rate 2 dual inline memory modules) that provide up to a maximum of 4.0 GB of system memory.

When installing memory modules, use the following guidelines:

vUse 1.8 V, 240-pin DDR2 SDRAM.

vUse 1 GB or 2 GB memory modules in any combination up to 4 GB.

To install or replace a memory module:

1.Removing the computer cover. See “Removing the computer cover” on page 86.

2.Lay the computer on its side.

3.Locate the memory slots. See “Identifying parts on the system board” on page 85.

Chapter 8. Replacing FRUs (Type 7848) 89