Lenovo E200 manual Diagnostic Error Code FRU/Action 170-0XX-XXX Flash system, XXX Information only

Diagnostic Error Code	FRU/Action
170-0XX-XXX	1.	Flash system
Voltage Sensor(s) failure
	2.	System board
170-195-XXX	Information only
Voltage Sensor(s) Test aborted by user	Re-start the test, if necessary
170-196-XXX	1.	Press F3 to review the log file
Voltage Sensor(s) test halt, error threshold
	2.	Re-start the test to reset the log file
exceeded
170-197-XXX	1.	Make sure the component that is called
Voltage Sensor(s) test warning
		out is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 49
	2.	Re-run test
	3.	Replace the component that is called out
		in warning statement
	4.	Replace the component under test
170-198-XXX	1.	If a component is called out, make sure
Voltage Sensor(s) test aborted
		it is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 49
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 111
	3.	Go to “Undetermined problems” on page
		78
170-199-XXX	1.	See “Undetermined problems” on page
Voltage Sensor(s) test failed, cause unknown
		78
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 111
	3.	Replace component under function test
170-250-XXX	1.	Power supply
170-251-XXX
	2.	System board
Voltage Sensor(s) Voltage limit error
170-254-XXX	1.	Voltage Regulator Module (VRM)
Voltage Sensor(s) Voltage Regulator Module
	2.	Microprocessor
error
	3.	System board
175-000-XXX	No action
Thermal Sensor(s) Test Passed
175-0XX-XXX	1.	Flash system
Thermal Sensor(s) failure
	2.	System board
175-195-XXX	Information only
Thermal Sensor(s) Test aborted by user	Re-start the test, if necessary
175-196-XXX	1.	Press F3 to review the log file
Thermal Sensor(s) test halt, error threshold
	2.	Re-start the test to reset the log file
exceeded

Chapter 7. Symptom-to-FRU Index 71