Lenovo E200 manual XXX Make sure the component that is called, 014-199-XXX, XXX No action

Diagnostic Error Code	FRU/Action
014-196-XXX	1.	Press F3 to review the log file
Parallel port test halt, error threshold
	2.	Re-start the test to reset the log file
exceeded
014-197-XXX	1.	Make sure the component that is called
Parallel port test warning
		out is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 49
	2.	Re-run test
	3.	Replace the component that is called out
		in warning statement
	4.	Replace the component under test
014-198-XXX	1.	If a component is called out, make sure
Parallel port test aborted
		it is connected and/or enabled
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 111
	3.	Go to “Undetermined problems” on page
		78
014-199-XXX	1.	Go to “Undetermined problems” on page
Parallel port test failed, cause unknown
		78
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 111
	3.	Replace component under function test
014-2XX-XXX	1.	External parallel device
014-3XX-XXX
	2.	System board
Parallel port failure
015-000-XXX	No action
USB port Interface Test Passed
015-001-XXX	1.	Remove USB device(s) and re-test
USB port Presence
	2.	System board
015-002-XXX	1.	Remove USB device(s) and re-test
USB port Timeout
	2.	System board
015-015-XXX	1.	Remove USB device(s) and re-test
USB port External Loopback failure
	2.	System board
015-027-XXX	1.	Flash the system. See “Flash update
USB port Configuration/Setup error
		procedures” on page 111
	2.	System board
015-032-XXX	System board
USB port Device Controller failure
015-034-XXX	1.	Reboot the system
USB port buffer
	2.	Flash the system and re-test. See “Flash
allocation failure
		update procedures” on page 111
	3.	Run memory test
	4.	System board
015-035-XXX	1.	Remove USB device(s) and re-test
USB port Reset condition detected
	2.	System board

62Lenovo E200 Hardware Maintenance Manual