Lenovo E200 manual Test results, Fixed disk advanced test Fdat

A selected test is marked by >>. Pressing the space bar again de-selects a test and removes the >>.

4.Repeat steps 2 and 3 above to select all desired tests.

Test results

Diagnostics test results produce the following error code format:

Function	Failure Type DeviceID	Date	ChkDigits	Text
Code

vFunction Code:

Represents the feature or function within the PC.

vFailure Type:

Represents the type of error encountered.

vDeviceID:

Contains the component’s unit-ID which corresponds to either a fixed disk drive, removable media drive, serial or parallel port, processor, specific RIMM, or a device on the PCI bus.

vDate:

Contains the date when the diagnostic test was run. The date is retrieved from CMOS and displayed using the YYYYMMDD format.

vChkDigits:

Contains a 2-digit check-digit value to ensure the following:

–Diagnostics were run on the specified date.

–Diagnostics were run on the specified computer.

–The diagnostic error code is recorded correctly.

vText:

Description of the error.

Note: See “Diagnostic error codes” on page 54 for error code listings.

Fixed disk advanced test (FDAT)

PC-Doctor Fixed-Disk1Advanced Test module (FDAT) is a full-featured highly configurable fixed-disk test suite. The configurable capabilities of FDAT allow users to enable or disable specific tests, enable or disable testing features, control the test log detail, alter testing parameters, and so on. FDAT tests for and reports most commonly found errors on a fixed-disk drive and is able to test up to 128 SCSI and 4 IDE drives (up to 132 total drives).

Drive information is gathered through FDAT’s enumeration of available devices and user specific configuration parameters located in the FDAT.INI. FDAT uses information supplied by these features to indicate specifically what devices are available for test, what tests are available for the device, device properties, and so on. To change testing parameters, you modify the FDAT.INI file in PC Doctor for DOS.

FDAT consists of the following subtests and features.

Fixed-Disk Tests:

1. The terms fixed disk and hard disk are used interchangeably.

Chapter 5. Diagnostics 45