Lenovo E200 manual 025-199-XXX, XXX No action, 030-00X-XXX Scsi signal cable 030-01X-XXX

Diagnostic Error Code	FRU/Action
025-198-XXX	1.	If a component is called out, make sure
IDE interface test aborted
		it is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 49
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 111
	3.	Go to “Undetermined problems” on page
		78
025-199-XXX	1.	Go to “Undetermined problems” on page
IDE interface test failed, cause unknown
		78
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 111
	3.	Replace component under function test
030-000-XXX	No action
SCSI interface Test Passed
030-00X-XXX	1.	SCSI signal cable
030-01X-XXX
	2.	Check power supply
SCSI interface failure
	3.	SCSI device
	4.	SCSI adapter card, if installed
	5.	System board
030-027-XXX	1.	SCSI signal cable
SCSI interface Configuration/Setup error
	2.	Flash the system. See “Flash update
		procedures” on page 111
	3.	SCSI device
	4.	SCSI adapter card, if installed
	5.	System board
030-03X-XXX	1.	SCSI signal cable
030-04X-XXX
	2.	Check power supply
SCSI interface error
	3.	SCSI device
	4.	SCSI adapter card, if installed
	5.	System board
030-195-XXX	Information only
SCSI interface Test aborted by user	Re-start the test, if necessary
030-196-XXX	1.	Press F3 to review the log file
SCSI interface test halt, error threshold
	2.	Re-start the test to reset the log file
exceeded
030-197-XXX	1.	Make sure the component that is called
SCSI interface test warning
		out is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 49
	2.	Re-run test
	3.	Replace the component that is called out
		in warning statement
	4.	Replace the component under test

66Lenovo E200 Hardware Maintenance Manual