Introduction
Connections - WBR-1100TX
| Figure 2: Connections - |
Printer Port | A standard parallel printer port is on the side panel. If you wish to |
| share a printer, connect it here. |
Serial (RS232) | A standard RS232 Serial Port is on the side panel. If you have an |
Port | analog modem or ISDN TA, connect it here. |
WAN port | Connect the DSL or Cable Modem here. If your modem came with a |
(10BaseT) | cable, use the supplied cable. Otherwise, use a standard LAN cable. |
DIP switches | Refer to the following table. |
PC port | If connecting directly to your PC (no Hub) use this port and a stan- |
(10/100BaseT) | dard LAN cable (RJ45 connectors). |
| Use EITHER the PC port OR the Hub port, NOT both. |
HUB port | Use a standard LAN cable (RJ45 connectors) to connect this port to a |
(10/100BaseT) | 10BaseT or 100BaseT hub. |
| Use EITHER the PC port OR the Hub port, NOT both. |
Reset Button | This button has three (3) functions: |
| • Reboot. When pressed and released, the LevelOne Wireless |
| Broadband Router will reboot (restart). |
| • Diagnostic |
| |
| • Ensure the printer is ready. |
| • Both Print LEDs will flash simultaneously during the diag- |
| nostic printing. |
| • Clear All Data. This button can also be used to clear ALL data |
| and restore ALL settings to the factory default values. |
To Clear All Data and restore the factory default values:
1.Power Off.
2.Hold the Reset Button down while you Power On.
3.Keep holding the Reset Button for a few seconds, until the RED LED has flashed TWICE.
4.Release the Reset Button. The LevelOne Wireless Broadband Router is now using the factory default values.
7
