Setup
LAN Screen
Use the LAN link on the main menu to reach the LAN screen An example screen is shown
below.
Figure 7: LAN Screen

Data - LAN Screen

TCP/IP
IP Address IP address for the LevelOne Wireless Broadband Router, as seen from
the local LAN. Use the default value unless the address is already in
use or your LAN is using a different IP address range. In the la tter case,
enter an unused IP Address from within the range used by your LAN.
Subnet Mask The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Subnet Mask for the LAN
segment to which the LevelOne Wireless Broadband Router is attached
(the same value as the PCs on that LAN segment).
DHCP Server If Enabled, the LevelOne Wireless Broadband Router will allocate
IP Addresses to PCs (DHCP clients) on your LAN when they start
up. The default (and recommended) value is Enabled.
If you are already using a DHCP Server, this setting must be
Disabled, and the existing DHCP server must be re-configured to
treat the LevelOne Wireless Broadband Router as the default
Gateway. See the following section for further details.
The Start IP Address and Finish IP Address fields set the values
used by the DHCP server when allocating IP Addresses to DHCP
clients. This range also determines the number of DHCP clients
supported.
See the following section for further details on using DHCP.
Buttons
Save Save the data on screen.
19